AOC 15 - Manual (Page 172)

Appendix I-2 Recommended Tools For Routine Maintenance
NOTICE: Use of the material contained in this document is subject to the warning on page Iv and the disclaimer on page v of this
document.
DOC012R02 AOC 15/50 User Manual Nov 2001
164
Tools Required For Field Service Maintenance
Check Qty Item USED ON
1 Spring Scale tip brake pull test
1 Quick-link tip brake pull test
2 ½ “combination wrench anemometer u-bolt
1 ¼” combination wrench anemometer
2 ½ inch socket, 3/8" drive tip brake nuts
2 9/16 inch socket, 3/8" drive tip brake nuts
2 3/8" drive socket wrench tip brake nuts, general
1 250 in-lb torque wrench tip brake nuts
2 5/32 Allen wrench hinge eye fastener
2 3/32 Allen wrench catch plate fastener (old)
1 5/16" Allen wrench Stearns brake cover fasteners
1 10 mm Allen wrench Ringfeder
1 Loctite 242 tip brake fasteners
1 Rounded Course File removing blade epoxy
1 Flat Steel Brush rust removal
2 Small round steel brush rust removal (approx. 5/8 diameter)
1 7/16" deepsocket, 1/2" drive
1 Marine Epoxy blade repair
1 Fine sandpaper for metal general, rust
1 Big adjustable wrench general
1 Small adjustable wrench general
1 Rubber Mallet general
1 Small sledge hammer general
1 Needle nose pliers general
2 Flat-head screwdriver general
2 Phillips-head screwdriver general
2 + Harnesses climbing
2 + Climbing hardware climbing
1 Rope hauling
1 Wire crimpers general
1 Wire strippers/cutter general
1 Electrical Tape general
1 Rust inhibitor general
1 Vise grips general
1 Small Pliers general
1 Channel Locks general
2 Small Screwdriver terminal strip
1 extractor tool general, blade cable
3 1.5 ft. bungee cords tip brake plate restraint
1 English allen set on keyring general
1 razor knife general