AMX Modero NXD-CV5 - Manual (Page 27)

Installation
15 NXD-CV5 5" Modero Wall/Flush Mount Touch Panel
These Bezel Kits require some assembly prior to installation onto the panel. Once assembled, the pre-existing
Faceplate can be removed and upgraded by using the following these steps.
1. To remove the current Faceplate, simply pull it away from the panel by gently tugging it outwards until
the entire Faceplate comes away from the panel.
2. Use the above table to determine which of the optional Trim Rings Kits will be used.
3. Assemble the Kit components:
To assemble the Bezel Kit with Buttons (FIG. 14):
a. From along the internal surface of the colored Faceplate, install the six colored buttons by firmly
inserting them into the button openings until the Button latch secures the button in place (FIG. 14).
b. Grasp the provided Button Trim Ring on both sides and fit it into the groove along the outside surface
of the Faceplate.
c. Gently insert the Button Trim Ring latches into their corresponding openings on the outer surface of
the internal Faceplate (FIG. 14).
FIG. 13 Trim Ring Kit Contents (Button and No-Button configurations shown)
FIG. 14 Installing the Button Bezel Kit (NXA-BEZ-5B)
(2 sets) (2 sets)
(2 sets) (2 sets)
- 2 Colored Faceplate/Bezels
- 2 Colored Button Trim Rings
- 2 Self-adhesive AMX labels
- 12 Colored Pushbuttons (2 sets of 6) - 2 Colored Faceplate/Bezels
- 2 Colored No-Button Trim Rings
- 2 Self-adhesive AMX labels
NXA-BEZ-5B With Buttons NXA-BEZ-5NB Without Button
Colored Button Trim Ring
Trim
Colored Faceplate
CV5 Panel/enclosure
Ring
Latches
(outside surface shown)
Button latch
Button installation
(showing the internal surface of Faceplate)