HP StorageWorks EVA Controller HSG V8.8 Software - Manual (Page 49)

Setting Up Notification
49 Command Console V2.5 User Guide
7. Check Alphanumeric if the paging system supports alphanumeric paging.
Leaving the box blank results in numeric paging only.
8. Type the pager identification number (PIN). (This is required for
alphanumeric pagers). If your numeric pager does not require a PIN, leave the
field blank. For example, this field must be blank for numeric pagers that are
assigned a unique telephone number.
9. Type the start and end times that this person is available for paging, in the
format HH:MM using a 24-hour clock. If you want 24 hour coverage, enter a
start time of 00:00 and an end time of 24:00. You must enter a time period for
paging. If you leave the start and end times at 00:00, paging is cancelled for
this person.
10. Click OK to close the Edit Profile dialog box.
Keep the following in mind:
■ If you dial a code to access an outside number, the code must precede the
phone number in the pager number field.
■ Do not use commas with alphanumeric pagers, except to access an outside
line.
■ You may need to add more commas to make the Command Console pause
long enough for the pager company greeting to complete.
■ Alphanumeric pagers require you to supply the paging service provider’s
TAP service modem number in the pager number field.
■ Not every paging company requires a PIN. If your pager is assigned a unique
phone number for calling the paging company, do not enter a PIN.
■ Alphanumeric pagers require a PIN.
■ Refer to your pager documentation to determine which special characters are
supported.
Figure 9 shows a sample user profile for an alphanumeric pager, and Figure 10
shows a sample user profile for a numeric pager.