HP Network Storage Router m2402 - Manual (Page 143)

Serial/Telnet User Interface
149 Network Storage Router M2402 User Guide
Note: A target ID must be defined in the SCSI Configuration to add devices.
3. In the Device List, to add a device to the map, enter the number from the
“Num” column.
If the selected device is already mapped, an error message will appear,
warning about adding a duplicate device.
Note: If a device with LUN = “-‘ is selected, all LUNs for this Target will be added to
the map.
Creating a Map Entry for a Fibre Channel Map
To pre-enter a map entry for devices that are not yet online, select Create (C).
Note: All essential information about the device must be known.
A series of questions are displayed. The questions will vary based on the ‘Current’
map protocol. Required information includes the LUN address, protocol, port,
device name, and device type must be entered.
Note: If the device being added is a SCSI device, the Target ID and LUN ID must be
entered. The Target ID must already be defined in the SCSI configuration.
Creating an Entry for a SCSI Map
To pre-enter a map entry for devices that are not yet online, select Create (C).
Note: All essential information about the device must be known.
A series of questions is displayed. The questions will vary based on the ‘Current’
map protocol. Required information includes the Target ID and LUN address,
protocol, port, device name, and device type must be entered.