HP Network Storage Router m2402 - Manual (Page 238)

Index
244 Network Storage Router M2402 User Guide
Visual Manager 87
filling entries
Serial/Telnet UI 143
Visual Manager UI 89
removing gaps in
Serial/Telnet UI 142
Visual Manager UI 89
viewing and changing
Serial/Telnet UI 132
Visual Manager UI 87
SCSI module
buffered tape writes
Serial/Telnet UI 128
Visual Manager UI 77
bus reset on boot
Serial/Telnet UI 126
Visual Manager UI 76
configuration of
Serial/Telnet UI 125
Visual Manager UI 74
default map
Serial/Telnet UI 128
Visual Manager UI 77
discovery settings
Serial/Telnet UI 126
Visual Manager UI 76
illustrated 6
image, illustrated 74
Initiator and Target settings
Serial/Telnet UI 126
Visual Manager UI 75
LED indicators 6
override settings 127
Visual Manager UI 77
termination mode
Visual Manager UI 76
thumbscrews and handle, illustrated 193
SCSI to Fibre Channel conversion process,
illustrated 11
security configuration
Serial/Telnet UI 117
Visual Manager UI 61
separating the inner and outer rails, illustrated
18
serial port
communications set up 31
connections 30
illustrated 8 , 30
location of 8
Serial UI, accessing 108
Serial/Telnet main menu, illustrated 110
Serial/Telnet UI
accessing 108
Active Fabric configuration 155
baud rate, changing 113
beacon mode, described 171
Configuration Menu, options, listed 112
DHCP setup 115
download new firmware option, described
174
editing host information on a Fibre Channel
module, illustrated 147
environmental status information, viewing
161
Ethernet configuration 114
DHCP 115
Ethernet mode 115
I/P address 115
I/P gateway 115
MAC address 115
subnet mask 115
event filter setting options, listed 153
event log
clearing 170
configuration of 152
viewing 170
event settings, configuration of 152
factory settings, resetting 157
Fibre Channel devices, viewing 165
Fibre Channel driver status information,
viewing 167
Fibre Channel link information, viewing 163
Fibre Channel module
buffered tape writes 123