HP Color LaserJet 8550 Multifunction Printer series - Manual (Page 155)

154 7 Printer Control Panel Messages EN
RESTORING
FACTORY SETTINGS The printer is resetting the
printer's factory defaults. The
printer is in the process of
completing a cold reset.
When the reset is completed,
the printer returns to the
ready state but remains
offline. Reset the EIO type and
configure the printer before
bringing the printer online. For
more information on factory
defaults and configuring the
printer control panel, see
chapter
2 , “ Using the Printer
Control Panel .”
SEPARATOR
OUTPUT BIN FULL The multi-bin mailbox output
bins are full. Remove all media from the
output bins on the multi-bin
mailbox to continue printing.
STACKER
OUTPUT BIN FULL The multi-bin mailbox output
bins are full. Remove all media from the
output bins on the multi-bin
mailbox to continue printing.
STAPLER LOW ON
STAPLES The Stapler Cartridge has 20
to 50 staples remaining. No action required.
STKR: ATTACH TO
PRINTER The device is not attached to
the printer properly. Make sure that there is a
proper attachment between
the device and the printer, and
wait for a solid green status
light on the user LED on the
device.
STKR: CLOSE
STAPLER DOOR The Stapler door is open or it
is not closed properly. Close the Stapler door
properly.
STKR: DETACH AND
CLEAR JAM A paper jam occurred in the
device. Clear the paper jam.
STKR: TRAY
OVERLOAD
alternates with
CLEAR PAPER FROM
OPTIONAL BIN 1
The weight capacity of the
stacker bin has been reached. Clear the paper from the
Stacker Bin.
Message Description Recommended Action