HP Color LaserJet 8550 Multifunction Printer series - Manual (Page 157)

156 7 Printer Control Panel Messages EN
TRANSFER KIT LOW
REPLACE KIT The transfer drum, transfer
belt, cleaning roller, and
charcoal filter are almost past
their specified life. Although printing can
continue, the transfer kit
should be replaced for
optimum printer operation. For
more information on replacing
the transfer kit, see the
installation guide included
with the transfer kit.
TRANSFER KIT OUT
REPLACE KIT The transfer drum, transfer
belt, cleaning roller, and
charcoal filter are past their
specified life. Replace the transfer kit and
reset the transfer counter
before attempting to print. For
more information on replacing
the transfer kit and resetting
the counter, see the
installation guide included
with the transfer kit. For more
information on configuring the
printer response to this
message, see “
Selecting
Toner Low Response ” in
chapter 2 .
TRAY 1 CONTAINS
UNKNOWN MEDIA Media was stacked in tray 1
for continuous manual feed
printing, and the job has been
completed. However, there is
still media in the input tray.
The printer considers the
input tray not to be
configured. Configure the media type for
tray 1 or remove the
remaining media. For more
information on configuring the
media type, see “
Printing from
Tray 1 ” in chapter 3 .
TRAY 1 LOAD
<Type> <Size> A user has requested a media
size that is not currently
installed in tray 1.
<Type> is the last media type
configured for the input tray.
<Size> is the last media size
configured for the input tray.
Load the media type and size
specified on the printer control
panel display. After the tray 1
is loaded, the printer
automatically brings itself
online.
For more information on
configuring the printer control
panel or checking printer
control panel settings, see
chapter
2 , “ Using the Printer
Control Panel .”
Message Description Recommended Action