HP 9000 Virtual Library System - Manual (Page 165)

Table 28 CLI Configuration Commands (continued)
Usage
1
Command
-p <s> - Product (DLT7000, SDLT320, ...) (required)
-pm <n> - FC port to which this tape drive is mapped. (required)
-r <s> - Revision (R138, ...) (required)
-t <s> - Tape drive type name (required)
-v <s> - Vendor (Quantum, HP, ...) (required)
-y <n> - Tape drive type (3, 4, ...) (required)
-h - Displays command usage information (optional)
Returns a list of all tape drives defined in the VLS. Where the options are:
-a <s>
- Library name (Library_0, ...) (required)
getTapeDrives
-h - Displays command usage information (optional)
Returns the configuration information for the specified tape drive. Where the options are:
-a <s>
- Name of desired tape drive (TapeDrive_1, ...) (required)
getTapeDrive
-h - Displays command usage information (optional)
Returns the R/W statistics of the specified tape drives. getTapeDriveStats
Returns the R/W statistics of all existing tape drives. getAllTapeDriveStats
Deletes the specified tape drive from the VLS. Where the options are:
-a <n>
- Node number on which the tape drive resides (0 to 3) (optional)
destroyTapeDrive
-f - Force. This parameter is ignored and is present only for backward compatibility
(optional)
-l <n> - LUN number of the tape drive to delete (1, 2, ...) (required)
-la <n> - Number of the node on which the library emulation to which the tape drive
is associated resides (required)
-ll <n> - LUN number of the library associated with the tape drive to delete (required)
-h - Displays command usage information (optional)
Creates a new barcode template. Where the options are:
-b <s>
- Barcode prefix to use for the barcode (up to 5 alpha characters) upper case
and/or numeric (required)
addBarCodes
-i <n> - Starting numeric value for the cartridges created with this template (1 to 1024)
(required)
-u <n> - Barcode suffix length. Number of digits for cartridge sequencing (1 to 16)
(required)
-s <n> - Barcode suffix to use for the barcode upper case and/or numeric (required)
-h - Displays command usage information (optional)
Returns a list of all the barcode templates (and their settings) that have been defined.
Displays each barcode template's name, prefix, start index, and suffix length. getBarCodes
Deletes the specified barcode template. Where the options are:
-a <s>
- Barcode prefix (required)
deleteBarCode
-f - Force. This parameter is ignored and is present only for backward compatibility
(optional)
-h - Displays command usage information (optional)
Gets cartridges by storage pool name. Where the options are:
-a <s>
- Storage pool name (StoragePool_#) (optional)
getCartsBySP
-h - Displays command usage information (optional)
VLS Commands 165