HP 9000 Virtual Library System User Manual
Page 210
7.
Press the latches upward until they are flush with the top edge of the controller, then turn the
thumbscrew on each latch clockwise until they are finger-tight.
The controller begins initializing.
The Power On/OK LED illuminates green when the controller completes initializing and is
online.
8.
Connect the disconnected cables to the new controller in reverse order of
.
9.
If you are replacing a RAID controller, restore the failed path:
a.
In Command View VLS, access the System tab.
b.
Select Storage LUNs from the navigation tree.
c.
Select View to display the storage LUN details.
d.
Select Fix Primary Paths from the task bar to display the Fix Primary Paths Wizard.
e.
Select Apply to set all paths back to their primary paths.
NOTE:
Upgrade of the firmware for the RAID controller’s components is automatically provided
by the operational controller and will occur within the first 10 minutes of power on. Upgrade of
the firmware on the expansion controller is not automatic; schedule a VLS restart if an upgrade is
needed. To check the current expansion controller firmware, use Command View VLS to review
the enclosure information on the System tab. For the enclosure repaired, compare the firmware
version on Disk Adapter 0 and Disk Adapter 1 and confirm they are the same. If the replacement
controller has a lower firmware version, HP recommends a VLS reboot at the earliest opportunity.
Earlier versions of the expansion controller firmware are supported by the current RAID controller
firmware.
210
Component Replacement