HP 9000 Virtual Library System - Manual (Page 184)

Status Description Item
Maintenance button 4 • To reset the switch — press and hold the Maintenance button for less than two
seconds. This action clears any temporary error conditions that may have
occurred and executes the switch self test.
•
To place the switch in Maintenance mode — press and hold the Maintenance
button for several seconds until the Heartbeat LED illuminates and then
extinguishes.
Green = The port is properly connected and able to communicate with its attached
devices. Port Logged-in LED (on
left for each port) 5
Off = One of these conditions exist:
•
The port connection is broken.
• An error occurred that disabled the port.
Green = data is passing through the port. Port Activity LED (on
right for each port)
Green = The port is properly connected and able to communicate with its attached
devices. Port Logged-in LED (on
top for each port) 6
Off = One of these conditions exist:
•
The port connection is broken.
• An error occurred that disabled the port.
Green = data is passing through the port. Port Activity LED (on
bottom for each port)
Ethernet Switch 2510–24 Components, LEDs, and Buttons
This section provides images and descriptions of the front and rear panels of the Ethernet Switch
2510–24.
Front Panel Components
Description Item
Console port 1
10/100Base-TX RJ-45 Ethernet ports 1 through 24
(numbered from left to right, top to bottom) 2
10/100/1000–T dual-personality ports 25 and 26 3
mini—GBIC dual-personality ports 25 and 26 4
184 Component Identification