HP 9000 Virtual Library System - Manual (Page 198)

2. Pull the hard drive (3) out of the node by the latch handle (2).
Figure 27 Removing a Node Hard Drive
To replace the component, pull out the latch handle (2) out as far as it can go and slide the drive
into the bay until the latch mechanism engages the chassis. Then, firmly push in the latch handle
to lock the drive in the drive bay.
Figure 28 Preparing the Node Hard Drive
Figure 29 Installing the Node Hard Drive
NOTE: The replacement drive is automatically configured to RAID 1; no administrator action is
required.
198 Component Replacement