HP 9000 Virtual Library System - Manual (Page 188)

Status Description Item
Mode select button: Port LED Mode select
button and indicator
LED 4
Press the button to step from one mode to the next. The current mode setting is
indicated by the Mode select LEDs near the button.
Mode select LED:
Link = Indicates that the port LEDs are displaying link information. If the port LED
is on, the port is enabled and receiving a link indication from the connected device.
If the port LED is off, the port has no active network cable connected, or is not
receiving link beat or sufficient light. Otherwise, the port may have been disabled
through the switch console, the Web browser interface. If the port LED is blinking
1 simultaneously with the Fault LED, the corresponding port has failed its self-test.
Act = Indicates that the port LEDs are displaying network activity information.
FDx = Indicates that the port LEDs are lit for ports that are in full-duplex mode. Off
indicates half duplex.
Spd = Indicates that the port LEDs are displaying the connection speed at which
each port is operating. If the port LED is off, the port is operating at 10 Mb/s. If
the port LED is flashing, the port is operating at 100 Mb/s, and if the port LED is
on continuously, the port is operating at 1000 Mb/s.
Usr = Indicates the port is displaying customer-specified information.
Blinking green = Data transfer between the switch and a USB device is occurring. Auxiliary LED 5
Green = The USB device is connected to the switch but no data transfer operation
is occurring.
Blinking orange (blinks every 1.6 seconds) = Indicates an error condition. The
switch Fault LED will be blinking simultaneously. There is a hardware fault associated
with the USB device or the USB connector on the switch.
Blinking orange = (blinks every 0.8 seconds) = Indicates an alert condition. The
switch Fault LED should not be blinking simultaneously. An alert error occurred in
the USB operation that is not caused by a hardware fault, such as a file transfer
error.
Off = Indicates that no USB device has been inserted, or that the inserted USB
device cannot be recognized, or that no command file can be found on the inserted
USB device.
Link: Port LEDs
Link (left) and Mode
(right) 6
•
Green = The port is enabled and receiving a link indication from the connected
device.
•
Off = The port has no active network cable connected, or is not receiving link
beat or sufficient light. Otherwise, the port may have been disabled through
the switch console, the web browser interface, or ProCurve Manager.
• Blinking orange simultaneously with the Fault LED = The corresponding port has
failed its self-test.
Mode:
The operation of the Mode LED is controlled by the LED Mode select button, and
the current setting is indicated by the LED Mode indicator LEDs near the button.
Press the button to step from one view mode to the next. The default view is Activity
(Act).
Link: Port LEDs
Link and Mode
(arrows pointing to
appropriate port) 7
•
Green = The port is enabled and receiving a link indication from the connected
device.
• Off = The port has no active network cable connected, or is not receiving link
beat or sufficient light. Otherwise, the port may have been disabled through
the switch console, the web browser interface, or ProCurve Manager.
•
Blinking orange simultaneously with the Fault LED = The corresponding port has
failed its self-test.
188 Component Identification