HP Secure Key Manager - Manual (Page 247)

Syslog Settings
To enable syslog, select a type of log, and click Edit. Specify a hostname or IP address of the primary
log server (Syslog Server #1) and the port that the syslog server is listening on. You can optionally
specify a backup syslog server by entering an IP address and port for the Syslog Server #2 IP and
Syslog Server #2 Port fields. Click Save when you are done.
Figure 137 Viewing the Syslog Settings section
NOTE:
Changes to the Syslog Settings section cause the KMS Server to restart, which takes the KMS offline
for a few seconds.
The following table describes the components of the Syslog Settings section.
Table 119 Syslog Settings section components
Description Component
You can enable syslog for the all SKM logs. Log Name
If there is a check mark in the box, syslog is enabled. If there is no check mark in the
box, syslog is disabled.
Enable Syslog
Specify a syslog server that should receive event notification messages. You can specify
a hostname or an IP address.
Syslog Server IP
Specify the port the syslog server is listening on. The default is 514. Syslog Server Port
The default is local1. You can choose from local0 to local7. Syslog Facility
Click Edit to modify the Syslog settings. Edit
Log Signing
Use this section to select the logs to sign.
Secure Key Manager 247