HP Officejet 100 Mobile Printer - L411a - Manual (Page 23)

1. Slide the battery into the battery slot at an angle, until the contacts on the battery
are flush with the contacts in the battery slot. The battery contact cover slides open.
2. Push the battery into the battery slot until the battery clicks into place.
3. Plug in the AC adapter and turn on the printer. Allow the battery to charge for four
hours before using the battery for the first time.
NOTE: After the first charge, the battery charge light is green when the battery
is charging, and turns off when the battery is fully charged.
4. After the battery is fully charged, you can use the printer without connecting to the
AC power supply.
To remove the battery
Follow these instructions to remove the battery.
1. Slide the battery release slider in the direction of the arrow.
2. Remove the battery.
Install and use the battery 19