HP Officejet 100 Mobile Printer - L411a - Manual (Page 49)

disabling the firewall. If the problem persists, the firewall is not the source of the
communication problem. Re-enable the firewall.
If disabling the firewall allows you to communicate with the printer, you might want to
assign a static IP address to the printer and re-enable the firewall.
Check the Bluetooth wireless connection
Printing larger files using a Bluetooth wireless connection can sometimes cause the
print job to fail. Try printing a smaller file. For more information, see Problems setting
up Bluetooth wireless communication.
Printer does not accept ink cartridge
Check the ink cartridge
•
Remove and reinstall the ink cartridge.
• Make sure the ink cartridge is inserted into its correct slot. Make sure the protective
tape has been completely removed from the ink cartridge. For more information,
see Replace the ink cartridges.
Clean the ink cartridge manually
Complete the ink cartridge cleaning procedure. For more information, see Advanced
ink cartridge maintenance.
Turn off the printer after removing the ink cartridge
After removing the ink cartridge, turn off the printer, wait about 20 seconds, and turn it
on again without the ink cartridge installed. After the printer has restarted, reinsert the
ink cartridge.
Printer takes a long time to print
Check the system resources
•
Make sure the computer has enough resources to print the document in a
reasonable amount of time. If the computer meets only the minimum system
requirements, documents might take longer to print. For more information on
minimum and recommended system requirements, see System requirements.
• If the computer is too busy running other programs, documents can print more
slowly. Try closing some programs, and then print the document again.
Check the printer software settings
Print speed is slower when Best or Maximum dpi is selected as the print quality. To
increase the print speed, select different print settings in the print driver. For more
information, see Print.
Check for radio interference
If the printer is connected using Bluetooth wireless communication and is printing
slowly, then the radio signal might be weak. For more information, see Problems
setting up Bluetooth wireless communication.
Solve printing problems 45