HP Designjet 5100 Printer series - Manual (Page 27)

2-3
Load and unload material
HP Designjet 5100 printer Customer Reference Guide
„ If you need to feed more printing material from the printer, and the ‘Move
Media’ screen is no longer displayed, go to the Media menu and press
Enter
. Then select ‘Move Media’.
„ If you are using a three-inch cardboard core, make sure the core
adaptors supplied with the printer have been installed.
Help with loading
When loading printing material there is information available from:
„ This Pocket Guide, installed at the back of the printer
„ The labels located on the printer and on the spindles
„ The front panel, which will guide you through the procedures step by step
Loading a roll onto the spindle
1 Make sure the printer wheels are locked (the brake lever is pressed down) to
prevent the printer from moving.
2 Remove the empty spindle by pulling firmly on each end A and then B as
indicated below.
The spindle has a stop at each end to keep the roll in position. The stop at
the left-hand end can be removed to mount a new roll, it slides along the
Core adaptors