HP Designjet 5100 Printer series User Manual
Page 35
2-11
Load and unload material
HP Designjet 5100 printer Customer Reference Guide
5 When you have adjusted the position of the core, pull the adjustment levers
on both spindle guides to the locked
position.
6 Pull the printing material taut to the position shown below. Do not attempt to
pull more material out of the printer; if you need more, use the front panel.
Use tape to secure the material to the core tube.
NOTE: To avoid the printing material skewing as it is wound onto the core
tube, ensure it is straight when it is attached.
7 Press the
↓
key on the front panel to advance the printing material. Advance
enough that the material can wrap at least once around the core.
8 Important: Press the wind button on the take-up reel panel indicated below
to wind the printing material once around the core.
9 Press the
↓
button on the front panel again to advance some more material:
enough to enable you to insert the media weight.
Advance about this
much paper