HP LaserJet Pro 100 color MFP M175nw - Manual (Page 144)

Change the product settings from a computer
NOTE: This tool is available only if you performed a full installation when you installed the product.
To change the product settings from a computer, open the HP Device Toolbox.
1. Click the Start button, and then click the Programs item.
2. Click your HP product group, and then click the HP Device Toolbox item.
The table below describes the basic product settings.
Tab or section Description
Status tab
Provides product, status, and
configuration information.
● Device Status: Shows the product status and shows the life remaining of
HP supplies, with 0% indicating that a supply is empty.
● Supplies Status: Shows the approximate percent life remaining of HP supplies.
Actual supply life remaining can vary. Consider having a replacement supply
available to install when print quality is no longer acceptable. The supply does not
need to be replaced unless the print quality is no longer acceptable.
● Device Configuration: Shows the information found on the product configuration
page.
● Network Summary: Shows the information found on the product network
configuration page.
● Reports: Allows you to print the configuration and supplies status pages that the
product generates.
● Color Usage Log: Shows a log that shows the user name, application name, and
color usage information on a job-by-job basis.
● Event Log: Shows a list of all product events and errors.
● Support button: Provides a link to the product support page. The Support button
can be password-protected.
● Shop for Supplies button: Provides a link to a page where you can order supplies
for the product. The Shop for Supplies button can be password-protected.
130 Chapter 12 Manage and maintain the product ENWW