HP LaserJet Pro 100 color MFP M175nw - Manual (Page 159)

Control panel message Description Recommended action
Memory is low
Press [OK]
The product does not have enough memory
to process the job. If the product is processing other jobs, send
the job again after those jobs have finished.
If the problem continues, turn off the power
by using the power switch, and then wait at
least 30 seconds. Turn on the power and
wait for the product to initialize.
Break the job into smaller jobs that contain
fewer pages.
Resend the print job in raster mode.
Set the “Print Data Optimization” setting in
the print driver to “Optimize for Raster”.
Memory is low. Only 1 copy made.
Press [OK] to continue
Product memory is too low to complete this
job. Either copy fewer pages at a time or turn off
collation.
If the error persists, turn the product off, and
then on.
Misprint
Press [OK]
The product has experienced an internal
hardware error. 1. Reprint the pages.
2. If the error persists, turn the product
off, and then on.
3. Print the pages again.
4. If the error persists, contact HP. See
www.hp.com/support/
LJColorMFPM175
or the support flyer
that came in the product box.
No paper pickup
Press [OK]
The product has experienced an internal
hardware error. 1. Verify that the media was inserted far
enough into the input tray.
2. Load the tray with the correct size of
paper for your job.
3. Make sure the paper guides in the tray
are adjusted correctly for the size of
paper. Adjust the guides so they are
touching the paper stack without
bending it.
4. Check the product control panel to see
if the product is waiting for you to
acknowledge a prompt to feed the
paper manually. Load paper, and
continue.
5. If the error persists, contact HP. See
www.hp.com/support/
LJColorMFPM175
or the support flyer
that came in the product box.
ENWW Interpret control panel messages 145