Approach Tech NVR-2018 - Manual (Page 56)

54
6.
6. Secure the driver in the rack using two
mounting screws in both the
side-mounting holes. Please don’t
tighten the screws too much, otherwise
that may damage the driver.
7.
8.
7. Screw the rack into the device, screwing
in all the four screws.
8. Attach the interface connector and the
power connector to the drive. Please
note the red lining of the IDE cable and
the red wire of power cable must line up
side by side.
10.
Place the mobile rack back onto the device and screw it in.
7.2 Mobile Rack
1. Make sure that the key unlocked.