Installation – Clinton Electronics CE-VF540 User Manual
Page 10
Installation
1. Bracket & Camera Mounting
- Affix the bracket to the mounting surface.
- Run cables through the center of the mounting bracket, or out the side slot.
2. Power Connector & Monitor Impedance
- Use a DC12V/1A regulated PSU or AC24V/1A.
- To avoid fire or shock hazards, always use a CE marked PSU.
- Set the monitor impedance switch to 75Ω. Check the impedance switch if
the screen is blurred.
3. Viewing Angle & Focus Adjustment
- To widen the viewing angle, loosen set screw and rotate the Zoom Lever to
the Left; rotate to the Right to narrow the viewing angle. Tighten set screw
when done adjusting.
- To adjust focus, loosen set screw, and rotate the Focus Lever Left or Right to
obtain proper focus. Tighten set screw when done adjusting.
4. Sunshield Mounting
- After completing view & focus adjustments, clip the sunshield into place.
5. Remote control & VBS Extra
- Remove the cap and connect the connector of the remote control and VBS
Extra to the cable socket.
6
Sales: 1-800-447-3306 Support: 1-800-549-6393 www.clintonelectronics.com
mounting screws
mounting plate
camera arm screws
Remote port
zoom
focus
Sunshield
cable routing:
center or side
CL
IN
TO
N
Ele
ctro
nics
CE
-V
F5
40
CL
IN
TO
N E
lect
ron
ics
CE
-V
F5
40