Exit – Clinton Electronics CE-VF540 User Manual
Page 29
Sales: 1-800-447-3306 Support: 1-800-549-6393 www.clintonelectronics.com
2) Set up the mode using the 4 direction buttons.
– CAM ID
: Determines the camera’s identification number
(between 0 and 255).
– BAUD RATE : Select 2400/4800/9600/19200/38400/57600 bps.
– UART MODE : Select NONE, EVEN or ODD for the parity bits.
– RET PKT
: Determines whether to send a command back to the
controller device when a communication control
command is sent to the camera.
– DISP ID
: Display the camera title on the top left corner of the
screen..
– PROTOCOL : STW(SPD), PELCO-D, PELCO-P, SEC, BOSCH,
HONEY WELL, VICON, PANA.
LANGUAGE : You can select the menu language according to your
requirements.
RETURN : Select this to save the SPECIAL menu settings and return to
the MAIN SETUP menu.
Select a desired EXIT mode using the Left and Right buttons depending on the
camera purpose.
– SAVE
: Save the current settings and exit the MAIN SETUP menu.
– NOT SAVE : Do not save the current settings and exit the MAIN SETUP
menu.
– RESET
: Resets the camera settings to the factory defaults. Language
and Monitor settings are not initialized.
Exit
a
COMM ADJ
continued
26