AT&T 76450 - Manual (Page 24)

Common Systems Connection Standards AT&T Services, Inc
Date: June 2013
ATT-TP-76450, Issue 15
Copyright © 2013, AT&T . All Rights Reserved.
Page 24
7 Vendor Documentation
The term “documentation” as used in this section refers to vendor documentation as defined in
GR-2914-CORE and GR-454-CORE.
Vendor documentation is an integral part of the network equipment and shall be
validated/tested by the vendor before delivery to AT&T to insure its accuracy,
comprehensibility, comprehensiveness and completeness as defined and measured by the
following documents and guidelines. Critical or Major Documentation deficiencies (determined
by AT&T) can delay equipment deployment until corrected by the vendor and approved by
AT&T. The requirements contained in this section are supplemental to other documents that
govern vendor documentation such as GR-454-CORE and GR-2914-CORE.
7.1 Softcopy Documentation
Documentation must be provided in both PDF and HTML format that is fully indexed and
fully searchable. Documents should be available on either web-site or CD. (use Check-list
to confirm source)
.
7.2 Craft Interface Instructions
Documents must provide step by step instructions for each procedure using Craft GUI, EMS
GUI, and TL1 (preferred) or equivalent commands.
Note: Items 7.4 and 7.5 Extend the testing procedure in GR-2914-CORE 20.8 Test Method for
Documentation Comprehension to include the complete “Installation Guide
7.3 Installation Guide: installation, provisioning, and testing of the network element
Vendor must test and validate that a new user can successfully install, provision, and test the
network element by following the “Installation Guide”.
7.4 Installation Guide: Creation, provisioning, and testing of a multi-node ring or
system
Vendor must test and validate that a new user can successfully create, provision, and test a
multi-node ring or system by following the “Installation Guide”.