Allied Telesis SB251-13 - Manual (Page 13)

Patch SB251-13 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches 13
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
The SET QOS VLANREMAP command was incorrectly saving
configuration files. This was resulting in errors occurring when the file was
executed. This issue has been resolved so that the file is saved in the correct
form.
CAM errors were appearing when the ENABLE SWITCH BIST command
was run multiple times. This issue has been resolved.
When line cards were hotswapped, the card’s STPs were not being correctly
reset to indicate that the card had been exchanged. This sometimes resulted
in a failure to select the preferred link, during the link re-establishment
phase. This issue has been resolved.
On the AT-9800, files with no extension were causing fatal errors when
stored on compact flash cards. This issue has been resolved to ensure that
these files are handled correctly.
On the AT-9800, the configuration file could be set from compact flash files
held in directories other than the root. This issue has been resolved by
preventing the configuration being set from files other than those located in
the root directory.
The prune time limit was not being cancelled when an IGMP join was
received by the switch. This was forcing the switch to send a Graft message
in the upstream direction. This issue has been resolved by cancelling the
prune time limit whenever an IGMP join is received.
When the SWITCH PORT command parameters, 10HMAUTO,
10MFAUTO, 100MHAUTO etc, were used to set a port to auto negotiate at
a particular speed, the port speed would not be retained following a card
hot swap. This issue has been resolved.
The PORT and PORTPRIORITY parameters of the STP PORT command
were not always updating switch instances on ports that are members of
multiple STP instances. This issue has been resolved.
When the switch received a generation ID change message, it was not
responding by sending a PIM HELLO message. This issue has been
resolved.
PCR: 031003 Module: QOS Level: 3
PCR: 031005 Module: SWCX Level: 3
PCR: 031006 Module: STP SWI Level: 2
PCR: 031007 Module: CFLASH Level: 2
PCR: 031008 Module: CFLASH INSTALL Level: 2
PCR: 031012 Module: PIM Level: 2
PCR: 031014 Module: SWCX Level: 2
PCR: 031015 Module: STP Level: 2
PCR: 031020 Module: PIM Level: 2
PCR: 031030 Module: SWCX Level: 3