Allied Telesis SB251-13 - Manual (Page 56)

56 Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
addresses in that range that were not allocated at that time, resulting in
duplicate addresses appearing on the free list for allocation. This has been
resolved by allowing DHCP to reclaim only those addresses that are
currently in use by one of its clients.
The PM table portmap was being updated each time a port was unplugged
or a link went down.
The port security feature of limiting the number of MAC addresses learned
on a port, was including static address entries even with the ADD SWITCH
FILTER command LEARN parameter set to default. This issue has been
resolved.
When AT-9800 Series switches, were operated in rapid STP mode, the point
to point field was not updating when speed or duplex changes occurred to
a port. This issue has been resolved.
When changing from RSTP to STP mode, the STP command RSTPTYPE
parameter was still appearing in the SHOW DYNAMIC command output.
This issue has been resolved so that the RSTPTYPE parameter is no longer
displayed in the command output.
Also when changing between RSTP and STP modes, disabled STP ports
were not remaining in the disabled state. This issue has also been resolved.
When changing from RSTP to STP mode, the STPCOMPATIBLE option for
the RSTPTYPE parameter incorrectly appeared in the dynamic
configuration. Also, when changing from RSTP to STP mode or vice versa,
disabled STP ports did not remain in the disabled state. These issues have
been resolved.
BGP routes that were added after a summary aggregate route had been
formed were not suppressed. This issue has been resolved: all routes added
after summary aggregate route creation are also now suppressed.
The SHOW BGP ROUTE command displayed unselected routes as the
"best" route, until they had been processed. This issue has been resolved.
When a single route was deleted from an aggregate route, the aggregate
route was deleted, even if it contained other routes. This issue has been
resolved.
The maximum Layer 3 throughput across line cards was only 25% under
some circumstances. This issue has been resolved.
A field has been added to the SHOW IP command output that displays
whether the IP ARP log is enabled or disabled.
PCR: 03709 Module: SWCX Level: 3
PCR: 03712 Module: SW Level: 3
PCR: 03716 Module: STP Level: 3
PCR: 03720 Module: STP Level: 1
PCR: 03720 Module: STP Level: 2
PCR: 03723 Module: BGP Level: 2
PCR: 03725 Module: SWCX Level: 3
PCR: 03728 Module: IPG Level: 4