Allied Telesis SB251-13 User Manual

Page 5

Advertising
background image

Patch SB251-13 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches

5

Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M

An unknown interface log message was returned for VRRP if there was an
interface UP or interface DOWN event due to a mismatch between a
monitored interface index and the corresponding interface instance. This
issue has been resolved.

The MLD snooping entries registered on a port were not removed when the
port went down or was unplugged. This issue has been resolved.

The IP multicast counter did not increment when IGMP, DVMRP and PIM
packets were transmitted and received. This issue has been resolved.

An error occurred in the GUI if it had been in operation for more than 20
days. This issue has been resolved.

Files used during start up were backed up from NVS to FLASH even if they
were already present in FLASH. This used up FLASH memory
unnecessarily. This issue has been resolved so that files are only backed up
when a copy does not already exist in FLASH.

If a configuration file had a long file name, the SHOW CONFIG command
displayed the file name using the shortened DOS 8.3 format (where file
names are 8 characters long, with extensions of 3 characters). This issue has
been resolved so that long configuration file names are now displayed using
the DOS 16.3 format (where file names are up to 16 characters long).

The TIMEOUT and SIZE parameters are only valid for the SET IP DNS
CACHE command, but no error message was returned if either parameter
was specified for the SET IP DNS command. This issue has been resolved.

Fragmentation of IPv6 packets now complies with RFC 2460’s requirement
to align packet sizes to 8 octets.

Disabled copper ports on AT-SB4411 8-Port (RJ-45) Gigabit Ethernet Line
Cards and AT-SB4441 8-GBIC Line Cards were not disabled on reboot. This
issue has been resolved.

The ENABLE RSVP INTERFACE command did not succeed if IP was
enabled after the RSVP interface had been created. Now, ENABLE RSVP
INTERFACE will succeed regardless of when IP is enabled as long as an IP
interface exists.

PCR: 03747

Module: VRRP

Level: 3

PCR: 03751

Module: MLDS

Level: 3

PCR: 03764

Module: IPG

Level: 3

PCR: 03769

Module: SWI

Level: 2

PCR: 03778

Module: FILE, INSTALL, SCR

Level: 2

PCR: 03780

Module: INSTALL

Level: 3

PCR: 03783

Module: IPG

Level: 3

PCR: 03784

Module: IPV6

Level: 3

PCR: 03791

Module: SWCX

Level: 2

PCR: 03793

Module: RSVP

Level: 3

Advertising