Allied Telesis SB251-13 User Manual

Page 23

Advertising
background image

Patch SB251-13 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches

23

Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M

If an IP address was added using the AD IP INTERFACE IP=DHCP and the
server could not assign an IP address due to a network problem affecting
the server’s VLAN, any further frames transmitted to IP addresses on other
VLANS would be blocked. This issue has been resolved.

Previously, the default output of the SHOW SWITCH FDB command
displayed the forwarding database information for ports on the controller
card located in bay A. The default now displays all external ports for switch
instances except for those on the controller card. This command no longer
displays information about internal ports.

Zmodem was not naming some loaded files. This issue has been resolved.

STP was advertising an incorrect length for BPDU packets. This issue has
been resolved.

Values for the KEEPALIVE and HOLDTIME parameters in the ADD BGP
PEER and SET BGP PEER commands were not interacting correctly. This
issue has been resolved.

The PURGE IP command did not remove ENABLE IP IGMP from the
configuration. This issue has been resolved.

IGMP queries were being sent after IGMP was disabled. This issue has been
resolved.

RIP Request packets for IPv4 were not being transmitted when the link came
up or when the switch restarted. This issue has been resolved.

When RIP interfaces were deleted, the IP routes learned through those
interfaces were not timing out correctly. Now, all IP routes learned though
a RIP interface are removed when the RIP interface is deleted, and no
timeouts occur.

QoS Traffic Class maximum bandwidth limiting was being overwritten by
the port or trunk maximum bandwidth value. This should only happen
when the Traffic Class maximum bandwidth has not been set manually with

PCR: 03224

Module: IPG

Level: 2

PCR: 03227

Module: SWI

Level: 4

PCR: 03229

Module: LOAD

Level: 3

PCR: 032231

STP

Level: 3

PCR: 03232

Module: BGP

Level: 3

PCR: 03234

Module: IPG

Level: 3

PCR: 03236

Module: IPG

Level: 3

PCR: 03237

Module: IPG

Level: 2

PCR: 03238

Module: SWI

Level: 2

PCR: 03239

Module: QOS

Level: 2

Advertising