Allied Telesis SB251-13 - Manual (Page 2)

2 Patch Release Note
Patch SB251-13 for Software Release 2.5.1
C613-10361-00 REV M
Some of the issues addressed in this Release Note include a level number. This
number reflects the importance of the issue that has been resolved. The levels
are:
Features in SB251-13
Patch SB251-13 includes all issues resolved and enhancements released in
previous patches for Software Release 2.5.1, and the following
enhancements:
MLD snooping is now supported on AT-9800 Series Switches. It is not
available on the SwitchBlade. Refer to the section, Multicast Listener
Discovery (MLD) Snooping For SwitchBlade and AT-9800 Series Switches shown
at the end of the SB251-13 features.
Sometimes IP flows were not deleted correctly when both directions of the
flow were in use. This issue has been resolved.
OSPF was disabling RIP unless RIP was activated using the SET OSPF RIP
command. This issue has been resolved.
Running the PURGE IP command with a multicast address and multiple
sources was causing a fatal error. This issue has been resolved.
The value specified for the IP parameter in the ADD FIREWALL POLICY
PROXY command was not being used by the HTTP proxy. This issue has
been resolved.
After about 250 days, commands such as SHOW BRIDGE COUNT were not
displaying the correct number of seconds for Uptime and Last Change At.
days. This issue has been resolved.
Level 1 This issue will cause significant interruption to network services, and
there is no work-around.
Level 2 This issue will cause interruption to network service, however there
is a work-around.
Level 3 This issue will seldom appear, and will cause minor inconvenience.
Level 4 This issue represents a cosmetic change and does not affect network
operation.
PCR: 02414 Module: IPV6, SWI, IPG, VLAN Level: 2
PCR: 03040 Module: IPG Level: 3
PCR: 03524 Module: OSPF, IPG Level: 2
PCR: 03530 Module: IPG Level: 2
PCR: 03542 Module: HTTP Level: 3
PCR: 03598 Module: ETH, IPG, IPv6, IPX,
PORT, PPP. Level: 3