Triton Perspective - Manual (Page 136)

128 | P a g e F e b r u a r y 2 0 1 1
6.2 Create Mosaic
6.2.1 Sidescan Processing Wizard
Sidescan data can be processed in Perspective Map using the MosaicOne Wizard. Presented
below are a few ways to launch the sidescan processing wizard.
During the raw data import process, the navigation data loads into the project first. If the raw
data files contain sidescan data then the MosaicOne Wizard will automatically launch and the
sidescan data can be processed as part of the import process.
However there are a few cases where the mosaic wizard should be canceled during the import
process and re-launched after the navigation data is properly processed. Reasons for skipping
the mosaic process upon import include:
1. The navigation data needs repeat processing.
2. The bottom tracking is not saved in the raw XTF data, so the mosaic will not be slant-
range corrected.
There are two methods to launch the MosaicOne Wizard manually from within Perspective
Map; from the File Tree or using the toolbar button.
1. To launch the wizard from the File Tree, right-click on the Imagery/Sidescan node and
selecting 'Create' as shown below:
2. The processing wizard can also be launched by selecting the 'Create Mosaic' toolbar
button:
Whether the processing wizard is automatically launched or manually as described above, the
same options are available. Processing steps in the MosaicOne Wizard are presented in the
following section.