9 17342 short-haul modem installation, 17342 short-haul modem installation – Campbell Scientific TurfWeather Weather Station User Manual

Page 38

Advertising
background image

TurfWeather Weather Station

3. Principle of Operation:

a. A Yagi high gain antenna is a directional RF device designed to

minimize signal attenuation at the base station location, thereby

providing the maximum available energy at the antenna for

communication with the remotely located weather station. This

antenna needs to be aimed and the best result is obtained with a clear

line-of-sight to the remote transceiver. If you can see the weather

station, the system has a clear line-of-sight.

b. The Polyphaser senses the presence of a high voltage electrostatic

energy pulse and passes it to earth ground before it can damage the

radio.

4. System Test:

a. Initiate the system software and verify that the radio will

communicate with the weather station. See Section 4, Quickstart

Guide.

5.4.9 17342 Short-Haul Modem Installation

1. Attach the enclosure from 17342 kit onto the tripod or mounting pipe

under the TurfWeather weather station using the supplied U-bolts. Mount

this underneath or opposite of the solar panel if used to prevent shadowing

on the solar panel (FIGURE 5-16).

2. Connect the 17326 cable to the connector on the bottom of the enclosure

marked

WEATHER STATION. Connect the other end of this cable to

the bottom of the weather station marked

RS-232 and thread the thumb

screws into the connector to secure the cable connector to weather station

(FIGURE 5-17 and FIGURE 5-18).

3. Connect the 12002 cable to the connector on the bottom of the enclosure

marked

COMPUTER. The other end of this cable has a red wire labeled

+RCV, a black wire labeled –RCV, a green wire labeled +XMT, and a

white wire labeled

–XMT. Connect these wires to the customer-supplied

cable using the direct burial splice kits. The wire used from the user-

supplied cable to connect to the red

+RCV wire should be connected to the

terminal marked

+RCV on the short haul modem used on the computer

end of cable run. The remaining wires should follow the same procedure

so that each wire is connected to the corresponding terminal on the short

haul modem.

28

Advertising