Anritsu Site Master S331D - Manual (Page 48)

87) SPA Multiple Upper Limit 1 End Y (Power Level) (lowest byte)
88-231) SPA Multiple Upper Limits 2-5, SA Multiple Lower Limits 1-5 (see bytes 72-87 for format)
232) RBW Setting (highest byte) 106
233) RBW Setting
234) RBW Setting
235) RBW Setting (lowest byte)
236) VBW Setting (highest byte) 107
237) VBW Setting
238) VBW Setting
239) VBW Setting (lowest byte)
240) OCC BW Method 108
241) OCC BW % Value (highest byte) 109
242) OCC BW % Value
243) OCC BW % Value
244) OCC BW % Value (lowest byte)
245) OCC BW dBc (highest byte) 110
246) OCC BW dBc
247) OCC BW dBc
248) OCC BW dBc (lowest byte)
249) Attenuation (highest byte)
250) Attenuation
251) Attenuation
252) Attenuation (lowest byte)
253) Antenna Index(0-14)
254-269) Antenna Name (16 bytes in ASCII)
270) Status Byte 1: ( 0b = Off , 1b = On)
(LSB) bit 0 : Spectrum Analyzer Mode Marker 1 On/Off
bit 1 : Spectrum Analyzer Mode Marker 2 On/Off
bit 2 : Spectrum Analyzer Mode Marker 3 On/Off
bit 3 : Spectrum Analyzer Mode Marker 4 On/Off
bit 4 : Spectrum Analyzer Mode Marker 5 On/Off
bit 5 : Spectrum Analyzer Mode Marker 6 On/Off
bits 6 - 7 : Not Used
271) Status Byte 2: (0b = Off, 1b = On)
(LSB) bit 0 : Transmission Mode Cal Status On/Off (Option 21)
bit 1 : Spectrum Analyzer Mode Marker 2 Delta On/Off
bit 2 : Spectrum Analyzer Mode Marker 3 Delta On/Off
bit 3 : Spectrum Analyzer Mode Marker 4 Delta On/Off
bit 4 : Pre Amp Mode (0b = Manual, 1b = Auto)
bit 5 : Pre Amp Status On/Off
bit 6 : Dynamic Attenuation On/Off
bit 7: Reserved
272) Status Byte 3: (0b = Off/Beep if data is BELOW line, 1b = On/Beep if data is ABOVE line)
LSB) bit 0 : SPA Limit Type (0b = Single, 1b = Multiple)
bit 1 : SPA Single Limit Beep On/Off
bit 2 : SPA Single Limit Status On/Off
bit 3 : SPA Single Limit Beep Level ABOVE/BELOW
42 Site Master PM
106 RBW frequency sent in Hz.
107 VBW frequency sent in Hz.
108 00h = % of power, 01h = dB down
109 0 – 99%
110 0 – 120 dBc