Anritsu Site Master S331D - Manual (Page 62)

bit 7: Not Used
299) Reference Level Offset 173 (highest byte)
300) Reference Level Offset
301) Reference Level Offset
302) Reference Level Offset (lowest byte)
303) External Reference Frequency 174
304) Signal Standard 175 (highest byte)
305) Signal Standard (lowest byte)
306) Channel Selection 176 (highest byte)
307) Channel Selection (lowest byte)
308) Interference Analysis Cellular Standard 177
309) Interference Analysis Estimated Bandwidth (highest byte)
310) Interference Analysis Estimated Bandwidth
311) Interference Analysis Estimated Bandwidth
312) Interference Analysis Estimated Bandwidth (lowest byte)
313) Interference Analysis Frequency 178 (highest byte)
314) Interference Analysis Frequency
315) Interference Analysis Frequency
316) Interference Analysis Frequency (lowest byte)
317-320) Reserved
321) Trigger Type 179
322) Trigger Position (0 – 100%)
323) Min Sweep Time (in ms) (highest byte)
324) Min Sweep Time (in ms)
325) Min Sweep Time (in ms)
326) Min Sweep Time (in ms) (lowest byte)
327) Video Trigger Level 180 (highest byte)
328) Video Trigger Level
329) Video Trigger Level
330) Video Trigger Level (lowest byte)
331) Status Byte 8 (0b = Off, 1b = On)
(LSB) bits 0-1: Trace Math Operation (00b = A only, 01b = A-B, 10b = A+B)
bit 2: Max Hold On/Off
bit 3: Min Hold On/Off
bit 4: Transmission Calibration On/Off (Option 21 only)
bit 5: Bias Tee On/Off (Option 10 only)
bit 6: Occupied BW Measurement On/Off
bit7: Not Used
332) Impedance (00h = 50W, 0Ah = 75W Anritsu Adapter, 0Ch = 75W Other Adapter)
333) Impedance Loss 181 (higher byte)
334) Impedance Loss (lower byte)
56 Site Master PM
173 Value sent as ( value in dBm * 1000 ) + 270,000
174 1 byte in MHz (i.e. 20 = 20MHz)
175 Index into Standard List (use control byte #89 to retrieve the ASCII string name). “No Standard” sent as FFFEh
176 “No Channel” is sent as FFFEh
177 4 Standards – 00h = 1250KHZ CDMA, 01h = GSM, 02h = TDMA, 03h = AMPS, 04h = Unknown FFh = Interference
Analysis Measurement OFF
178 Scaled by Frequency Scale Factor (bytes 335-336)
179 Trigger Type – 00h = Single, 01h = Free Run, 02h = Video, 03h = External
180 Value sent as ( value in dBm * 1000 ) + 270,000
181 Value sent as (value in dB * 1000), valid values are 0 to 20 dB