Axis Communications LBP 5200 - Manual (Page 314)

Installing the Network Board (AXIS 1611) 6-19
Optional Accessor
ies
6
Removing the Network Board
Remove the network board using the following procedure. Prepare the protective
plate for the expansion board slot that you removed when you installed the network
board.
CAUTION
• Make sure that the printer is turned off and that all interface cables and power
cord are disconnected from the printer before removing the network board.
Attempting to remove the board with the power on may result in electrical
shock.
• Take care when you are handling the network board. Do not touch the corners or
sharp areas of the network board as may cause personal injury.
1
Press the power switch to turn the printer off, remove the USB
cable, and disconnect the power plug from the power outlet.
2
Remove all the interface cables and the power cord from the
printer.
3
Remove the 2 screws and remove the network board.
Store the network board in the protective bag that it came in.
IMPORTANT
• Do not touch any of the components, printed wiring, or connectors on the network
board.
• The screws that were removed are used to attach the protective plate.
4
Attach the protective plate to the expansion slot and secure it
with the screws.
5
Connect the interface cables except for the USB cable, and
connect the power cord.
6
Plug the power plug into the AC power outlet.
7
Connect the USB cable.