Axis Communications LBP 5200 - Manual (Page 37)

Connecting to a Computer 1-14
Bef
ore
Y
ou Star
t Using
This Pr
inter
1
• A USB cable is not supplied with this printer. Obtain a USB cable that matches the
computer you are using.
1
Plug the B-type (square) end of the USB cable into the USB
socket on the rear side of the printer.
2
Plug the A-type (flat) end of the USB cable into the USB port
on the computer.
NOTE
• If the Plug and Play automatic setup feature of the computer displays a Wizard
after you connect the USB cable, install the printer software using one of the
following procedures. Refer to "Installing the CAPT Software," on p. 3-5 for more
details.
- Click [Cancel] and install the software from CD-ROM Setup.
- Install the software using Plug and Play.
• If you are not sure about the USB cable that is supported by your computer, contact
the store where you purchased the computer.