Axis Communications LBP 5200 - Manual (Page 38)

Connecting to a Computer 1-15
Bef
ore
Y
ou Star
t Using
This Pr
inter
1
Using a LAN Cable
When the optional network board (AXIS 1611) is installed, the printer can be
connected to a network using a LAN cable. The cables, hubs, etc. should be
obtained separately as required.
NOTE
• For details on the procedure for installing the network board, see "Installing the Network
Board (AXIS 1611)," on p. 6-12.
• If this printer is connected to a network, network settings will need to be configured, the
printer will need to be installed as a network printer, the print server will need to be
configured, etc. For information on the steps required, refer to the users manual included
with your network operating system and the users manual included with AXIS 1611.
■ Network Environment
The optional network board supports 10BASE-T and 100BASE-TX connections.
• When connecting to a 10BASE-T Ethernet network
• When connecting to a 100BASE-TX Ethernet network
IMPORTANT
• The network board for this printer cannot connect to networks other than those listed
above.
• Make sure there is port available on the hub you will connect to. If there are no available
ports, the hub will need to be expanded.
10BASE-T
Cable
LAN Connector 10BASE-T Compatible Hub
Computer with a
10BASE-T Connector Computer without a
10BASE-T Connector
10BASE-T Compatible
Network Board
LAN Connector 100BASE-TX Compatible Hub
100BASE-TX
Cable
Computer with a
10BASE-T Connector Computer without a
10BASE-T Connector
10BASE-TX
Compatible Network Board