A.J. Antunes & Co VCT-20 9200552 - Manual (Page 5)

5
VERTICAL CONTACT TOASTER
P/N 1010719 Rev. E 02/13
Voltage Watts Amps Hertz
208 3400 16.3 60
220 3800 17.3 60
240 4525 18.9 60
SPECIFICATIONS
Electrical Specifications at Listed Voltages
Electrical Cord & Plug Configurations
CAUTION
All electrical connections must be in accordance
with local electrical codes and any other applica-
ble codes.
WARNING
ELECTRICAL SHOCK HAZARD. FAILURE TO
FOLLOW THE INSTRUCTIONS IN THIS MANUAL
COULD RESULT IN SERIOUS INJURY OR DEATH.
• Electrical ground is required on this appliance.
• Do not modify the power supply cord plug. If
it does not fit the outlet, have a proper outlet
installed by a qualified electrician.
• Do not use an extension cord with this appli-
ance.
• Check with a qualified electrician if you are in
doubt as to whether the appliance is properly
grounded.
Letter Description Configuration
Code*
V NEMA-6-20P
20 Amp, 250 VAC
I International Pin & Sleeve
IEC-309
32 Amp, 230 VAC
C Commercial Cord
H Harmonized Cord
* Used in Model Designation
IMPORTANT SAFETY INFORMATION (continued)
• When installing conveyor belt wrap, be careful
not to wrap it over the upper and lower sup-
port rods or permanent damage to belt will
occur. Make sure belt wrap is positioned
UNDER the upper and lower support rods.
• Make sure both ends of belt wrap are aligned
evenly before installing belt wrap pin.
• Failure to use release sheets may result in
damage to the equipment and loss of warran-
ty coverage.
• All electrical connections must be in accor-
dance with local electrical codes and any
other applicable codes.
• WARNING ELECTRICAL SHOCK HAZARD.
FAILURE TO FOLLOW THESE INSTRUCTIONS
COULD RESULT IN SERIOUS INJURY OR
DEATH.
- Electrical ground is required on this appli-
ance.
- Do not modify the power supply cord plug.
If it does not fit the outlet, have a proper
outlet installed by a qualified electrician.
- Do not use an extension cord with this
appliance.
- Check with a qualified electrician if you are
in doubt as to whether the appliance is
properly grounded.
Model Designation
TYPE OF POWER CORD
H = HARMONIZED
C = COMMERCIAL
TYPE OF PLUG
I = International Pin and Sleeve
S = Straight Twist-Lock
V = NEMA 6-20P
VCT-20XX