Vertical surfaces – Cyclades PR1000 User Manual
Page 16
Advertising
Cyclades-PR1000
Chapter 2 - What is in the Box
16
Next, place the PR1000 on the horizontal surface, aligning the fuzzy and prickly Velcros® as shown in Figure 2.4.
Cyclades-PR1000
Horizontal Surface Where the PR1000 Will be Secured
FIGURE 2.4 HOW TO ATTACH THE PR1000 TO A HORIZONTAL SURFACE
Vertical Surfaces
There are two slots in the base of the PR1000 to allow it to be affixed to a vertical surface. Screws and nylon
fixings (for cement walls) are provided for this purpose.
Make holes 184,8mm (7.27 in) apart on the vertical surface. If using a drill, a 5mm bit should be used. Four
millimeters (or a little more than 1/8 in) of the screw should be exposed (not counting the head).
Advertising