Cyclades PR1000 - Manual (Page 27)

Cyclades-PR1000
27 Chapter 4 - Step-by-Step Instructions
STEP THREE
The network protocol parameters, shown in Figure 4.4, are similar to those for the Ethernet interface. Fill in the
parameters for your network in the right-most column.
Menu CONFIG=>INTERFACE=>SWAN=>NETWORK PROTOCOL=>IP
Parameter
Example Your Application
Active or Inactive Active enables IP communication (IPX and
Transparent Bridge are not used in this
example).
Interface Unnumbered/
Numbered Numbered
Primary IP Address 0.0.0.0 (This number will be assigned by the
Access Provider dynamically.)
Subnet Mask 255.0.0.0
Secondary IP Address 0.0.0.0 for none
IP MTU Use the preset value, 1500. This determines
whether or not a given IP datagram is
fragmented.
NAT Global Assigned because the IP address of
the SWAN interface will be assigned
dynamically.
Enable Dynamic Local IP
Address Yes, because the IP address of the SWAN
interface will be assigned dynamically.
Remote IP Address Type Any
Remote IP Address 0.0.0.0
ICMP Port Inactive
Incoming Rule List Name None, filters are not included in this example.
Outgoing Rule List Name None, filters are not included in this example.
Routing of Broadcast
Messages Inactive
FIGURE 4.4 SWAN NETWORK PROTOCOL (IP) MENU PARAMETERS