Cyclades PR1000 User Manual
Page 31
Cyclades-PR1000
31
Chapter 4 - Step-by-Step Instructions
Menu CONFIG=>STATIC ROUTES=>IP=>ADD ROUTE
Parameter
Example
Your Application
Destination IP Address
Type in the word "DEFAULT".
Gateway or Interface
Gateway
Gateway IP address
Use the same value as for
Destination IP Address in the
previous table.
Metric
1
Is This a Backup Route?
No
OSPF Advertises This
Static Route
No
FIGURE 4.8 STATIC ROUTE MENU PARAMETERS FOR GATEWAY ROUTE
STEP SEVEN
NAT must now be activated. There are two varieties of NAT: Normal and Expanded. This example uses the
Normal NAT Mode. The other mode is explained in the chapter on NAT in the Installation Manual.
Menu CONFIG =>SECURITY =>NAT =>GENERAL
Parameter
Example
Your Application
Nat Status
Enabled
Nat Mode
Normal
Disable Port Translation
No
FIGURE 4.9 NAT GENERAL PARAMETERS
STEP EIGHT
NAT parameters will now be determined for routing outside of the local LAN. Network Address Translation maps
the local IP addresses, registered in the local address range menu below, to the one global IP address assigned
by the access provider. Local IP addresses not indicated in this menu will be discarded.