Static routes – Cyclades PR1000 User Manual
Page 30
Cyclades-PR1000
30
Chapter 4 - Step-by-Step Instructions
STEP SIX
Two static routes must be added to tell the router that all traffic not intended for the local LAN should be sent to the
Access Provider. Chapter 9 of the Installation Manual explains static routes and other routing methods available
in CyROS. Fill in the spaces in Figures 4.7 and 4.8 with the values for your application.
Menu CONFIG=>STATIC ROUTES=>IP=>ADD ROUTE
Parameter
Example
Your Application
Destination IP Address
This IP address must match
the IP
address
given in figure 4.6
(CONFIG=>SYSTEM=>MODEMS=>
DIAL OUT TABLE=>ADD=>IP
ADDRESS)
Subnet Mask
The subnet mask for
the Destination
IP Address
.
255.255.255.255
Gateway or Interface
Interface
Interface
SWAN
Is This a Backup Route?
No
OSPF Advertises This
Static Route
No
FIGURE 4.7 STATIC ROUTE MENU PARAMETERS FOR INTERFACE ROUTE