AMX NetLinx Integrated Controllers NI-3000 - Manual (Page 113)

NetLinx Security with a Terminal Connection
107 NetLinx Integrated Controllers
Logging Into a Session
Until Telnet security is enabled, a session will begin with a welcome banner.
Welcome to NetLinx v2.10.80 Copyright AMX Corp. 1999-2004
>
When Terminal security is enabled, the user will be prompted for a user name and password before
they will be allowed to access any commands available from Telnet. No welcome banner will be
displayed until a valid login is made. When the session is started, the user will see a login prompt as
seen below:
Login:
The user (Login) name is case sensitive. The user name must be entered with the exact combination
of upper and lower case letters as was assigned to them by the security administrator. The user
name must be at least 4 characters long and no more than 20 characters. Any combination of letters,
numbers, or other characters may be used.
The user would enter their user name and then would be prompted for a password:
Login: User1
Password:
Help Menu Options (Cont.)
Command Description
SET DNS <D:P:S> Setup the DNS configuration of a device.
SET ICSP PORT Sets the IP port listened to for ICSP connections.
SET ICSP TCP TIMEOUT Sets the timeout period for ICSP and i!-WebControl TCP connections.
SET IP <D:P:S> Setup the IP configuration of a device.
SET TELNET PORT Sets the IP port listened to for Telnet connections.
SET THRESHOLD Sets the Master's internal message thresholds.
SET TIME Set the current time.
SET URL <D:P:S> Setup the initiated connection list URLs of a device.
SHOW COMBINE Displays a list of devices, levels, and channels that are currently com-
bined.
SHOW DEVICE <D:P:S> Displays a list of devices connected and attributes.
SHOW LOG <START> Display the message log. <start> specifies message to begin the
display. 'all' will display all messages.
SHOW NOTIFY Display the Notify Device List (Master-Master).
SHOW REMOTE Displays the Remote Device List (Master-Master).
SHOW ROUTE Displays the Master's routing information.
SHOW SYSTEM <S> Displays a list of devices in a system.
TCP LIST Displays a list of active TCP connections.
TIME Display the current time.
URL LIST <D:P:S> Display the initiated connection list URLs of a device.
SSL SECURITY
ENABLE:DISABLED
Enables or Disables the Web Server SSL security.
The welcome banner is not displayed for Terminal sessions.