AMX NetLinx Integrated Controllers NI-3000 - Manual (Page 15)

Introduction
9 NetLinx Integrated Controllers
NI-3000 Specifications (Cont.)
IR/Serial (Ports 9-16) • Eight IR/Serial control ports support high-frequency carriers up to
1.142 MHz
• Each output is capable of two electrical formats: IR or Serial
• Eight IR/Serial data signals can be generated simultaneously
• Channel range = 1-32,767
• Channels 1-128 (output): IR commands
• Channels 129-253: used as reference channels
• Channel 254 (feedback): Power Fail (used with 'PON' and 'POF'
commands)
• Channel 255 (feedback): Power status (when IO Link is set)
• Two 8-pin 3.5 mm mini-Phoenix (female) connectors provide IR/Serial port
termination
Program port • Single RS-232 DB9 connector (male) can be connected to a DB9 port on a
computer; used with serial commands, NetLinx programming commands,
other DB9 capable devices, and to upload/download information from the
NetLinx Studio 2.2 program.
Configuration DIP switch • Use this DIP switch to set the communication parameters for the rear
RS232 Program port.
ID pushbutton • Sets the NetLinx ID (D) assignment for the device.
• The D notation is used to explicitly represent a device number.
Ethernet port • Single RJ-45 port for 10/100 Mbps communication. The Ethernet Port
automatically negotiates the connection speed (10 Mbps or 100 Mbps) and
whether to use half duplex or full duplex mode.
Ethernet Link/Activity LED • LEDs show communication activity, connections, speeds, and mode
information:
SPD-speed - Yellow LED lights On when the connection speed is 100 Mbps
and turns Off when the speed is 10 Mbps.
L/A-link/activity - Green LED lights On when the Ethernet cables are
connected/terminated correctly and blinks when receiving Ethernet data
packets.
AXlink LED • One green LED indicates the state of the AXlink connector port.
• Normal AXlink activity = 1 blink/second
• Abnormal AXLink activity = cycle of 3 consecutive blinks and then Off
AXlink port • 4-pin 3.5 mm mini-Phoenix (male) connector provides data and power to
external control devices.
Power port • 2-pin 3.5 mm mini-Phoenix (male) connector
Included Accessories: • 4 CC-NIRC IR Emitters (FG10-000-11)
• One 10-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5107)
• Two 8-pin 3.5 mm mini-Phoenix (female) Relay connector (41-5083)
• One 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)
• One 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)
• Installation Kit (KA2105-01):
One 8-pin Relay Common Strip (41-2105-01)
Four rack mount screws (80-0186)
Four washers (80-0342)
• Removable rack ears. Allows for tabletop and under-counter mountings