AMX NetLinx Integrated Controllers NI-3000 - Manual (Page 20)

Introduction
14 NetLinx Integrated Controllers
NI-4000 Specifications (Cont.)
CardFrame Number
DIP switch • Sets the starting address for the Control Cards in the CardFrame.(Factory
default CardFrame DIP switch value = 0).
• The Control Card address range is 1-3064.
NetLinx Control Card
connectors (1-4) • Four 20-pin (male) connectors that bridge the gap between the Control
Cards in the CardFrame and external equipment.
Included Accessories: • Two CC-NIRC IR Emitters (FG10-000-11)
• One 10-pin 3.5 mm mini-Phoenix (female) I/O connector (41-5107)
• Two 8-pin 3.5 mm mini-Phoenix (female) Relay connector (41-5083)
• One 4-pin 3.5 mm mini-Phoenix (female) AXlink connector (41-5047)
• One 2-pin 3.5 mm mini-Phoenix (female) PWR connector (41-5025)
• Installation Kit (KA2105-01):
One 8-pin Relay Common Strip (41-2105-01)
Four rack mount screws (80-0186)
Four washers (80-0342)
• Removable rack ears. Allows for tabletop, under-counter, and
front/rear rack mounting
Optional Accessories: • 2 Pin Black Male Phoenix Connector (3.5mm) (41-5026)
• CC-NIRC IR cables (FG10-000-11)
• CC-NSER IR/Serial cables (FG10-007-10)
• CSB Cable Support Bracket (FG517)
• NCK, NetLinx Connector Kit (FG2902)
• NI-4000 Quick Start Guide (93-2105-01)
• PSN2.8 12 VDC power supply (FG423-17)
• PSN6.5 12 VDC power supply (FG423-41)
• STS, Serial To Screw Terminal (FG959)
• Upgrade Compact Flash (factory programmed with firmware):
NXA-CFNI64M - 64 MB compact flash card (FG2116-31)
NXA-CFNI128M - 128 MB compact flash card (FG2116-32)
NXA-CFNI256M - 256 MB compact flash card (FG2116-33)
NXA-CFNI512M - 512 MB compact flash card (FG2116-34)
NXA-CFNI1G - 1 GB compact flash card (FG2116-35)
• NXC cards (see the Card Slot section (page 12) of this Specification table
for more detailed information)