Agilent Technologies N-Series - Manual (Page 18)

User’s Manual Page 2-18
figure 2.4
CAUTION: Controller boards are sensitive to
static electricity. Before proceeding with the
removal of your printer’s controller board,
discharge any static electricity from your body
by touching something metal, such as the metal
plate on the back of the printer. Do this BEFORE
you handle the controller board.
▲
Remove the controller board by grasping both
thumbscrews and pulling toward you with firm and even
force. Place the controller on the ream of paper.
Inserting the X/TRA XLi
▲
Locate the XNIO slot on the controller board.
▲
Remove the two screws on each side of the X/TRA XLi’s
mounting bracket
▲
With the phillips screwdriver, remove the plate covering
the interface port. Do
not discard the plate. not discard the plate. not discard the plate. not discard the plate. not discard the plate.
▲
Slide the parallel interface and interface cord of the XLi
through the open interface port
▲
Line up the X/TRA XLi’s connector to the slot on the
controller board and slide the coax interface through the
port opening so that card is properly aligned.