Agilent Technologies N-Series - Manual (Page 58)

SECTION 5
XTRAEDIT CONFIGURATION
General Information
XTRAEDIT is a menu-driven, MS/PC DOS-based utility that enables
users to change the default configuration of the XLi. XLi. Configuration
changes made with this software will be saved in the XLi's permanent,
nonvolatile storage, even when power has been disconnected from the
unit.
Getting Started
Loading XTRAEDIT
Start by connecting the XLI to the host system and to the printer as
described in Section 2 — Installation. Then load and run XTRAEDIT, the
XLI configuration software. If the user’s 3.5" high-density disk drive has
a letter designation other than B, or if the user is running the software
after installing it on a hard drive, substitute the appropriate letter and
subdirectory name for B in these instructions.
At the B:> prompt, type: XTRAEDIT[enter]
About XTRAEDIT
After a few seconds, the XTRAEDIT program will load, and the “About
XTRAEDIT” screen will appear.
After reading the information presented, mouse users can clear this dialog
box by pressing the left mouse button after moving the mouse pointer
either to OK or to the Close button in the upper left corner of the dialog
box. Keyboard users can close this dialog box either by pressing s to
close or d to accept OK (the highlighted choice).
This screen also can be displayed by the user at any time during
configuration by selecting About, found under the Help menu. When
selected from the Help menu, this dialog box will also provide users with
information about the amount of remaining memory available in the
user’s computer.