Agilent Technologies N-Series - Manual (Page 9)

Page ix
Select Port .................................................................................. 5-6
XLI Resources Directory .............................................................. 5-6
Exit — Alt-X ............................................................................... 5-7
Configure Menu ..............................................................................5-7
Select Configuration to Edit ........................................................5-8
Change Default Configuration .................................................... 5-9
Text Generation ........................................................................ 5-10
Font Selection ........................................................................ 5-10
Font Rotation ......................................................................... 5-10
Language ............................................................................... 5-11
Character Set ......................................................................... 5-11
Line Spacing .......................................................................... 5-11
Absolute Line Spacing............................................................ 5-11
Justification ............................................................................ 5-11
Printer Setup ............................................................................. 5-12
Input Tray Selection ............................................................... 5-12
Input Paper Size ..................................................................... 5-12
Input Tray Map ....................................................................... 5-13
Output Tray Selection ............................................................ 5-13
Output Tray Map .................................................................... 5-13
Two-up Printing ...................................................................... 5-14
Source Code .................................................................................. 5-14
Duplex ................................................................................... 5-15
Page Length (Portrait, Landscape) .......................................... 5-15
Size Correction ...................................................................... 5-16
Top Offset .............................................................................. 5-16
Left Offset.............................................................................. 5-17
Minimum Top Coordinate ....................................................... 5-17
Minimum Left Coordinate ...................................................... 5-17
Margins (Portrait, Landscape) .................................................... 5-18
Top Margin ............................................................................. 5-18
Bottom Margin ....................................................................... 5-19
Left Margin ............................................................................ 5-19
Right Margin .......................................................................... 5-19
Tabs (Portrait, Landscape) ......................................................... 5-19
Other Options ........................................................................... 5-22
Emulation Mode..................................................................... 5-23
Line End ................................................................................. 5-23
Units of Measure .................................................................... 5-24
Uppercase Commands............................................................ 5-24
UDK Character ...................................................................... 5-24
Job Timeout ............................................................................ 5-24
Job Sheet................................................................................ 5-24