Agilent Technologies N-Series - Manual (Page 56)

Page 4-35 XES COMMANDS
3 Dutch
4 Spanish
5 Italian
6 Danish
7 Norwegian
8 Finnish
9 German
A Swedish
B Belgian
C French Canadian
D Portuguese
E Latin American
F The Default Language
G The Special Table (3274)
H User-defined Table
Belgian and Portuguese are EBCDIC tables and are not supported by the
X/TRA XLi. It will use The Default Table instead. The XLi supports
language tables only for ISO character set fonts. Fonts that do not support
the ISO character set will not be remapped based upon language and will
always use their built-in character set.
The fonts built in to Xerox printers that are simulated by the XLi do not
support the ISO character set and therefore do not support language
selection. If the user needs language support for these fonts, the user must
either download or install in the XLi’s flash memory the real versions of
these fonts using XTRAEDIT. Language is supported only if Character Set
is set to ASCII.
Data Monitor
▲
COMMAND: COMMAND: COMMAND: COMMAND: COMMAND:
s
+D +D +D +D +D
▲
RANGE: RANGE: RANGE: RANGE: RANGE: N/A N/A N/A N/A N/A
This command prints the hexadecimal codes representing all characters
received by the printer. This allows the user to analyze data being sent
from the host. Data Monitor Mode must be exited with the Reset
command.