Form merge start, Cycleforms, Form merge stop – Agilent Technologies N-Series User Manual
Page 50: Page merge start
Page
4-29
XES COMMANDS
This command assigns a number to one of up to ten forms which can then
be recalled for merging into a variable document, where # is the number
(0-9) to be assigned and formname.FRM is the name of the form to which
the number is being assigned. This command is placed anywhere on the
variable page after the Print Job command and before the first Form Merge
Start command.
Form Merge Start
▲
COMMAND:
COMMAND:
COMMAND:
COMMAND:
COMMAND:
s
zb#
zb#
zb#
zb#
zb#
▲
RANGE:
RANGE:
RANGE:
RANGE:
RANGE:
0-9
0-9
0-9
0-9
0-9
This command invokes a form with an assigned identification number for
merging with a text document, where # is the form ID number.
Cycleforms
▲
COMMAND:
COMMAND:
COMMAND:
COMMAND:
COMMAND:
s
zx
zx
zx
zx
zx
form
form
form
form
form
1
1
1
1
1
,form
,form
,form
,form
,form
2
2
2
2
2
,…forrm
,…forrm
,…forrm
,…forrm
,…forrm
64
64
64
64
64
d
▲
RANGE:
RANGE:
RANGE:
RANGE:
RANGE:
1-64
1-64
1-64
1-64
1-64
This command enables repeated merging of a set of forms at specified
intervals in a job consisting of multiple variable pages, where form
1
, form
2
and form
n
are the names of the forms as they are stored on disk. The
commas are used not only to separate form names, but can also be used to
indicate any variable pages in which merging is not to occur. This
command is placed after the Print Job command in the first series of
variable pages to be merged.
Form Merge Stop
▲
COMMAND:
COMMAND:
COMMAND:
COMMAND:
COMMAND:
s
zh#
zh#
zh#
zh#
zh#
▲
RANGE:
RANGE:
RANGE:
RANGE:
RANGE:
0-9
0-9
0-9
0-9
0-9
This command stops the merging of a form with a variable page, where #
is the number (0-9) of the form to be stopped.
Page Merge Start
▲
COMMAND:
COMMAND:
COMMAND:
COMMAND:
COMMAND:
s
ze
ze
ze
ze
ze