Sony VGF-HS1 - Manual (Page 64)

6
VGF-HS1 3-98-360-11(1)
Error message Causes/measures
LAN cable not connected  The network cable is not properly connected. Connect the cable
properly. Refer to the Setup Guide and see “Connecting to a network.”
Nothing to copy.
Press OK  There are no files to be imported with the One Touch Copy function
on the connected device. Capture new photos or videos first and then
use the One Touch Copy function.
 You might have pressed the COPY button without connecting a copy
source device. Connect your device.
NOTICE:
Firmware update ready  A firmware update was downloaded. Access the Home Server Settings
Page and update your Home Server (page 52).
NOTICE:
Important message  An important message was downloaded. Check the Home Server
Settings Page (page 20) for the message.
Obtaining Confirmation code
failed.
Press OK  A confirmation code was not obtained during the course of creating a
Data Sync (transmitting) profile. Check your Home Server for Internet
access (page 42).
Obtaining Permission code
failed.
Press OK  A permission code was not obtained during the course of creating a
Data Sync (transmitting) profile. Check your Home Server for Internet
access (page 42).
Scanning
Hard drive…  A hard disk failure has occurred and the checking is now in progress.
Wait until the checking completes without turning off your Home
Server.
Shared folder maximum
reached
Press OK  The number of shared folders has already reached the limit. Go to the
Shared folders page on the Home Server Settings Page (page 22) and
delete unnecessary shared folders.
Unit temp.
too high  Heat is building up inside your Home Server. Place the Home Server in
a place with good ventilation. Refer to the Setup Guide and see
“Precautions on placement” as well.