Sony DCR-IP210 - Manual (Page 204)

204
Maintenance information and precautions
Adjusting the LCD screen (CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the
procedure below.
(1) Set the POWER switch to (CHG) OFF.
(2) Eject the tape from your camcorder, then disconnect any connecting cable from
your camcorder.
(3) Close the LCD panel with the LCD screen facing out.
(4) Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL,
then keep pressing DISPLAY/TOUCH PANEL for about five seconds.
(5) Follow the procedure below with your finger or the supplied stylus (DCR-
IP220 only).
1 Touch at the upper left corner.
2 Touch at the lower right corner.
3 Touch in the middle of the LCD screen.
If you do not press the right spot, always returns to the position at the upper
left corner.
Note
You can only carry out this operation with the LCD screen in the step 3 position.
CALIBRATE CALIBRATE CALIBRATE
PB FN
DISPLAY/TOUCH PANEL